Filter
Top Products
Operating Your Radio
25
Nothing Comes Close to a Cobra
®
ATIS ID Programming
24
English
Bluetooth
®
Mode Pairing
and Programming
Operating Your Radio
Bluetooth Radio On/Off
This setting allows you to turn On and Off the small Bluetooth
radio inside this VHF radio. The default setting
is ON. Turning it Off can save some power. It can easily
be switched On at any time.
To Set Bluetooth On and Off:
1.
Display will show the word blue and ON or OFF flashing.
2.
Press Channel UP/Down button to select ON or OFF.
3. Press the Call/Enter/Setup button to save this entry.
You have now ended Bluetooth Setup mode programming
and will enter ATIS ID programming.
BluetoothRadio On
BluetoothRadio Off
ATIS ID Programming
•
The Automatic Transmission Identification System (ATIS) feature of this Cobra radio
is used to identify marine vessels in some inland waterways of European countries
that require ATIS transmission. An ATIS ID number is required to operate the ATIS
feature. The ATIS ID number is derived from your vessels call sign. You must enter
your ATIS ID number into this radio before the ATIS system will become functional.
Please consult your local dealer for questions about local ATIS requirements. The use of
ATIS is prohibited outside the European inland waterways covered by the Basel Agreement.
With this feature activated the vessels ATIS ID number is transmitted after every
push of the Talk button.
Channel Up/Down Button
ATIS ID Number Entry
To Set the ATIS ID Number:
NOTE
The ATIS ID is a 10 digit number that will always
begin with the number “9.” You will be asked to enter
only the last nine digits. The first digit, “9”, has been
automatically entered for you.
1. With the radio turned Off; press and hold the Channel
Down and SCAN buttons and simultaneously power
On the radio.
2. The LCD will display and flash the ATIS icon.
A dash (-), to the right of the digit “9”, will be flashing
for the next entry.
NOTICE
Remember, you only have one (1) attempt
to set the ATIS
ID number. Once this number has been entered, only your
Cobra distributor can reset the ATIS IDnumber. You can also
return the radio to Cobra for reprogramming.
3. Press the Channel Up/Down button to scroll through
the specific ATIS digit being entered.
4. Pressing the Call/Enter/Setup button advances to the
right, one (1) digit, for the next entry.
5. Repeat this input sequence until all nine digits have
been entered. The ATIS icon will stop flashing when a
successful ATIS ID entry has been made.
6. Press the Call/Enter/Setup button again, after all
numbers have been entered, to save the ATIS ID
number and return to the Marine Standby mode.
ATIS ID Start Screen
and SCAN Buttons
Channel Down
MRHH475EU_MANL_vC.qx:MRHH475_ENG_Body 12/28/09 9:44 AM Page 24