Cobra Electronics MRHH475FLTBTEU Marine Radio User Manual


 
34
English
35
Nothing Comes Close to a Cobra
®
Mobile Phone Operation
With Bluetooth
®
VHF Marine Radio Protocols
Operating Your RadioVHF Marine Radio Protocols
Rewind Operation
Operating Your Radio
Rewind Countdown Timer
SCAN Button Enter Record
Using Rewind-Say-Again
TM
to Record Audio
Transmission:
1. Press and hold SCAN button for two (2) seconds to
enter Record mode.
2. Press and hold TALK button to begin recording
from radio microphone. If TALK button is released,
recording stops. While recording, a 20-second
countdown begins on display. When 20-second
countdown time has ended, recording stops and
two (2) beep tones will be heard.
3. Press and hold SCAN button again for two (2)
seconds or press MEM/ESC button to cancel
recording and return to last operation.
NOTE
When using radio in Record mode, the REW feature
is turned Off to prevent “recording over” previous
message.
Answer Incoming Phone Calls
This handheld radio, once properly paired to your Bluetooth
®
compatible mobile phone, can answer incoming calls received
on your mobile phone. It can act as the speaker and microphone,
while your mobile phone stays safe and dry. It will also
improve audio quality on both ends of the conversation.
To Answer and End an Incoming Call:
1. The speaker on the HH475 will ring. The display will
change and show the word “AnSEr” as shown.
2. Press and release the Bluetooth button on the MR
HH475BT front panel. After the call is answered, the
LCD will switch to “Connct” as illustrated.
3. Begin conversation with the caller by a pressing the
PTT (Push to Talk) key and speaking into the small
microphone above the LCD. This is very similar to a
standard radio operation and it completely eliminates
all background noise when you are not speaking.
NOTE
To enable hands free conversation or “VOX” mode
(pressing in the PTT key not required), use the
Channel Up and Channel Down keys anytime when
in Bluetooth mode. The “VOX” icon will turn on when
VOX mode is enabled.
The Bluetooth “VOX” setting does NOT reset to Off
after a power cycle unlike the normal VOX associated
with VHF mode.
4. To end a call, press and release the Bluetooth button.
The HH475 will then return to previous Standby mode
and resume normal operation.
Answering a Call
NOTE
Please refer to the Bluetooth Mode Pairing and Programming section on
page 21 for instructions on how to pair your mobile phone with this device,
change ring tones, etc. The following section covers how to complete a
phone call and other basic operations.
Mobile Phone Operation with Bluetooth
®
BluetoothButton
Connected to a Call
MRHH475EU_MANL_vC.qx:MRHH475_ENG_Body 12/28/09 9:44 AM Page 34