Filter
Top Products
7
Installation Instructions
Connect the water inlet hose to the connector by
turning the connecting nut.
Be sure a rubber
ring is inside the
connecting nut.
Plate
Release
button
Connecting
nut
Water
inlet hose
Rubber
Ring
To release, turn off the water faucet and press the
release button to release the pressure of water
then press down the plate.
CONNECTING THE
WATER SUPPLY HOSE
Do not unscrew the lid of the hot water connector on the
water mixing valve, and then connect the other end of
water inlet hoses to the cold connector in water mixing
valve by turning the connecting nut.
Hot water
connector
Cold water
connector
Connecting
Nut
Water
inlet hose
Lid of
hot water
connector
Rubber
Ring
2
If you have both cold and hot water supplied, connect the inlet hose cold to cold and hot to hot.
Connect the water inlet hose to the tap connector by
turning the connecting nut.
Water faucet
Rubber
ring
Connecting nut
Water
inlet hose
To release, turn off the water faucet and turn on the
washer to run about 5 minutes and then disconnect the
inlet hoses.
Unscrew the lid of the hot water connector in water mix-
ing valve, and then connect the other end of water inlet
hoses to the connectors in water mixing valve by turning
the connecting nut.
Hot water
connector
Cold water
connector
Water
inlet hose
Rubber
ring
Connecting
nut
Note:
1. Do not over tighten or cross thread the nut in order to prevent the elbow of the water inlet from breaking.
2. If water seeps, you should check the nut to see if there is a rubber sealed ring.