Filter
Top Products
Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 101
March 2012
Section 8 - Conguring Client Quality of Service (QoS)
Field Description
Drop Select Drop to specify that all packets for the associated trafc stream are to be dropped if
the class map criteria is met.
Mark Class of
Service
Select this eld to mark all packets for the associated trafc stream with the specied class
of service value in the priority eld of the 802.1p header. If the packet does not already
contain this header, one is inserted. The CoS value is an integer from 0 – 7.
Mark IP DSCP Select this eld to mark all packets for the associated trafc stream with the IP DSCP value
you select from the list or specify.
Select from List
Select from a list of DSCP types.
Match to Value
Enter a DSCP Value to match (0 – 63).
Mark IP Precedence Select this eld to mark all packets for the associated trafc stream with the specied IP
Precedence value. The IP Precedence value is an integer from 0 – 7.
Disassociate Class
Map
Select this option and click Apply to remove the class selected in the Class Map Name
menu from the policy selected in the Policy Map Name menu.
Member Classes Lists all DiffServ classes currently dened as members of the selected policy. If no class is
associated with the policy, the eld is empty.
Delete Policy Map Select this eld to delete the policy map showing in the Policy Map Name menu.
Table 55 - DiffServ Policy Map
To delete a Policy Map, select the Delete Policy Map option and click Apply.
Client QoS Status
The Client QoS Status page shows the client QoS settings that are applied to each client currently associated with
the AP.
To view QoS settings for an associated client, click the Client QoS Status tab.
Figure 62 - QoS Conguration Status For Associated Clients
Field Description
Station The Station menu contains the MAC address of each client currently associated with the AP.
To view the QoS settings applied to a client, select its MAC address from the list.
Global QoS Mode Shows the current Client QoS Global Admin Mode on the AP.
Client QoS Mode Shows whether the QOS mode for the selected client is enabled or disabled.
Note: For the Qos Mode to be enabled on a client, it must be globally enabled on the AP
and enabled on the VAP the client is associated with. Use the VAP QoS Parameters page
to enable the QoS Global Admin mode and the per-VAP QoS Mode.
Bandwidth Limit Up Shows the maximum allowed transmission rate from the client to the AP in bits per second
(bps). The valid range is 0 – 4294967295 bps.
Bandwidth Limit
Down
Shows the maximum allowed transmission rate from the AP to the client in bits per second
(bps). The valid range is 0 – 4294967295 bps.