D-Link DWL-2600AP Marine Radio User Manual


 
Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 57
March 2012
Section 4 - Managing the Access Point
Figure 27 - Congure WDS Bridges
Before you congure WDS on the AP, note the following guidelines:
•) When using WDS, be sure to congure WDS settings on both APs participating in the WDS link.
•) You can have only one WDS link between any pair of APs. That is, a remote MAC address may appear only
once on the WDS page for a particular AP.
•) Both APs participating in a WDS link must be on the same Radio channel and using the same IEEE 802.11
mode. (See “Modifying Radio Settings” on page 40 for information on conguring the Radio mode and
channel.)
•) When 802.11h is operational, setting up two WDS links can be difcult.
To congure WDS on this AP, describe each AP intended to receive handoffs and send information to this AP. For each
destination AP, congure the elds listed in the table below.
Field Description
Spanning Tree
Mode
Spanning Tree Protocol (STP) prevents switching loops. STP is recommended if you
congure WDS links.
Select Enabled to use STP
Select Disabled to turn off STP links (not recommended)
Radio For each WDS link on a two-radio AP, select Radio One or Radio Two. The rest of the
settings for the link apply to the radio selected in this eld. The read-only Local Address will
change depending on which Radio you select in this eld.
Local Address Indicates the MAC addresses for this AP.
For each WDS link on a two-radio AP, the Local Address reects the MAC address for the
internal interface on the selected radio (Radio One on wlan0 or Radio Two on wlan1).
Remote Address Specify the MAC address of the destination AP; that is, the AP on the other end of the WDS
link to which data will be sent or handed-off and from which data will be received.
Click the drop-down arrow to the right of the Remote Address eld to see a list of all the
available MAC Addresses and their associated SSIDs on the network. Select the appropriate
MAC address from the list.
Note: The SSID displayed in the drop-down list is simply to help you identify the correct
MAC Address for the destination AP. This SSID is a separate SSID to that which you set for
the WDS link. The two do not (and should not) be the same value or name.
Encryption You can use no encryption, WEP, or WPA (PSK) on the WDS link.
If you are unconcerned about security issues on the WDS link you may decide not to set
any type of encryption. Alternatively, if you have security concerns you can choose between
Static WEP and WPA (PSK). In WPA (PSK) mode, the AP uses WPA2-PSK with CCMP
(AES) encryption over the WDS link.
Table 27 - WDS Settings