Filter
Top Products
10
Align plastic ratchets in bracket.
2. Aligning the transducer on the transom. Slide the transducer
between the two ratchets. Temporarily slide the bolt though the trans-
ducer assembly and hold it against the transom. Looking at the trans-
ducer from the side, check to see if it will adjust so that its face is par-
allel to the ground. If it does, then the "A" position is correct for your
hull.
If the transducer's face isn't parallel with the ground, remove the
transducer and ratchets from the bracket. Place the ratchets into the
holes in the bracket with the letter "B" aligned with the dot stamped in
the bracket.
Reassemble the transducer and bracket and place them against the
transom. Again, check to see if you can move the transducer so it's par-
allel with the ground. If you can, then go to step 3. If it doesn't, repeat
step 2, but use a different alignment letter until you can place the
transducer on the transom correctly.
Dot