Filter
Top Products
18
Install batteries in battery compartment (left).
Attach power cable, and route wires as shown (right).
CAUTION:
When using the sonar in a saltwater environment, we strongly
recommend that you unplug the power connector from the bat-
tery socket when the unit is not in use. When the unit is turned
off but still connected to a power supply, electrolysis can occur in
the power cable plug. This may result in corrosion of the plug
body along with the electrical contacts in the cable and the
unit's power socket.
Mounting the Unit
A quick-release mount is built into the top of the portable power pack. To
attach the unit, first plug in the cable connector. Then, hold the sonar unit
vertically and slide it onto the bracket from above. (The back of the unit
should be touching the front of the bracket as you lower it into position.)
As you push down, the unit will lock into place with a distinct click.
To adjust the viewing angle, pinch the quick-release mount's ratchets
with one hand, then tilt the unit with your other hand. Release the
ratchets and the unit locks into the new position. To remove the unit
from the PPP-12, press the ratchets and lift the unit off the bracket.
Cable slot
in case wall
Route this
cable through
o
p
enin
g