![](http://pdfasset.owneriq.net/e/18/e18af223-311c-8424-1d3a-37fd4359fd06/e18af223-311c-8424-1d3a-37fd4359fd06-bg13.png)
13
Align plastic ratchets in bracket.
B. Two-piece bracket: Locate the four plastic ratchets in the trans-
ducer's hardware package. Press two ratchets into the sides of the plastic
bracket and two on either side of the transducer as shown in the follow-
ing illustrations. Notice there are letters molded into each ratchet. Place
the ratchets into the bracket with the letter "A" aligned with the align-
ment mark molded into the bracket. Place the ratchets onto the trans-
ducer with the letter "A" aligned with the 12 o'clock position on the
transducer stem. These positions set the transducer's coarse angle ad-
justment for a 14° transom. Most outboard and stern-drive transoms
have a 14° angle.
Insert and align ratchets.
Dot
Alignment letters
Alignment
positions
Transducer
Trans
ducer
bracket