Filter
Top Products
29
Screw the suction cup onto the bracket using the supplied screw and
flat washer. Tie the nylon cord through the hole in the top of the
bracket. When using this transducer, tie the other end of the nylon cord
to the boat. This will help prevent the loss of the transducer if it comes
off the boat.
Portable transducer assembly: rear view (left) and side view (right.)
Clean the chosen area of the hull before attaching the suction cup. Lo-
cate the transducer on the hull as shown in the following figure. Don't
allow the bracket to extend below the hull, because water pressure
against it can cause the suction cup to come off at speed.
Washer
Washer
Nut
Bolt
Screw
Suction
cup
Transducer
Tie nylon
cord
here