Filter
Top Products
31
To use the plotter, simply press the PLOT key. A screen
similar to the one at the bottom of the previous page
appears.
The flashing cross is your present position. The solid
line is your current track, or path you have just traveled.
The large square is a compass rose marked with North,
South, East, and West. The square’s height and width
shows at the bottom of the screen. This is the distance
from one side to the other and from the top to the bottom.
Your present position is shown at the top of the screen.
If your present position starts to move outside the
square, the AccuNav Sport™ clears the display, then
redraws your present position closer to the center of the
screen. Your present position will always be displayed
on the plotter. To clear the plotter screen, see the Plotter
Menus section.
On the left side of the screen are the Distance To Go
(DTG), Speed Over Ground (SOG), Bearing (BRG), and
Course Over Ground (COG) digital displays. All of these
displays are only used when a waypoint is recalled,
except COG and ALT which are always active. These
displays also can be customized. See the Plotter Menus
section for more detail.
PLOTTER CURSOR
The plotter cursor can help you determine the latitude/
longitude of a waypoint or event marker. To use it, press
the up or down arrow key while the plotter is displayed.
A screen similar to the one on the next page appears.
Two new lines appear on the screen. These are the
plotter cursor lines. Also, the present position display at
the top of the screen switches to show the latitude/
longitude position of the plotter cursor - not your present
position. The distance and bearing from your present