Filter
Top Products
setdomainmode(8)
154 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised March 2008
-m function=mode Sets the modes of operation and specifies its values. Use function
to set the modes of operation. One of the following can be
specified:
diag Specifies the OpenBoot PROM diagnostic
level.
secure Specifies whether to enable or disable the
host watchdog and suppress break signal
reception.
autoboot Specifies whether to enable or disable the
Auto boot function.
cpumode Sets the operational mode of CPU.
When diag is specified for function, any of the following can be
specified for mode:
Note – This function cannot be specified for the domain which is
powered on.
none No diagnosis is performed.
min Sets standard for the diagnostic level.
max Sets maximum for the diagnostic level.
When secure is specified for function, one of the following can
be specified for mode. The setting will be reflected after domain
power on or restart.
on Enables the host watchdog and suppress
break signal reception.
off Disables the host watchdog and suppress
break signal reception.
When autoboot is specified for function, one of the following
can be specified for mode. The setting will be reflected after
domain power on or restart.
on Enables the Auto boot function.
off Disables the Auto boot function.