3-8
3.11 Function Controls
The function controls (F1 and F2) work like
the auto-dialing feature of a telephone, auto-
matically executing the function assigned to
them. The function can be turned off by press-
ing appropriate function control again.
Default settings
F1: Shift (brief press) or Zoom (long press)
F2: Ring brilliance
How to register menu items
1. Press the [MENU] key.
2. Press [A/C SEA] (F1) or [A/C RAIN] (F2)
to open the function menu.
[ SETTING FOR F1 KNOB ]
SSel by omnipad & press ENT.S
EBL
OFFSET
SHIFT ZOOM
RINGS
MODE
DISP
DATA
MARK
BRILL
NOISE
REJ
TRAIL
TONE
PULSE
LENGTH
CHARA
CTERS
NO
FNCTN
WPT
MARK
WATCH
MAN
CUSOR
POSITN
EBL
REF
GUARD
IN/OUT
NAV
TALKER
OWN
POSITN
DEAD
SECTOR
VECTOR
LENGTH
VECTOR
REF
OTHER
MENU
SHIFT/
ZOOM
ECHO
TRAIL
TRAIL
TIME
ALARM
LEVEL
PANEL
DIMMER
VRM
UNIT
HIS
TORY
COLLI
SION
AUTO
ACQ
ECHO
STRTCH
INT
REJECT
TRAIL
ON/OFF
TUNE
A/M
Figure 3-11 Function menu
3. Select function desired.
4. Press the [ACQ/ENTER] key.
5. Press the [MENU] key to close the menu.
3.12 Suppressing Noise
Electrical noise can be suppressed by turn-
ing on “8. NOISE REJ” on the OTHERS
menu.
3.13 Adjusting Brilliance of
Markers
“2. Mark Brill” on the OTHER menu adjusts
the brilliance of markers other than the head-
ing marker.
3.14 Outputting Target Position
Radar target position data can be output to a
navaid in IEC 61162 format. Select the radar
target with the cursor, and then press and
hold down the [TLL] key to output the data.
This function requires position data and head-
ing signal.
3.15 Dead Sector
When the scanner is installed at a close dis-
tance in front of the wheelhouse the radar
should be set not to transmit within that area,
to prevent microwave hazard. Ask your
FURUNO representative ordealer to provide
this feature.