Filter
Top Products
3. SETTING AND ADJUSTMENT
3-9
Scanner setting
1. Open the INITIALIZE menu described on page 3-3 and 3-4.
2. Press [3] key to open the SCANNER menu.
[SCANNER]
1 BACK
2 BLIND SECTOR 1
START 000°
ANGLE 000°
3 BLIND SECTOR 2
START 000°
ANGLE 000°
4 ANT REVOLUTION
LO/HI/AUTO
5 ANT SW
OFF/ON
6 ANT STOPPED
STBY/TX
7 M SPEC
OFF/ON
8 BB TYPE
NORMAL/BB
9 [DUAL RADAR]*
Note 1: Set the blind sector as minimum as possible.
Note 2: Do not set the blind sector in the bow direction.
*non IMO-type only
To close the menu, press the [MENU] key.
BLIND SECTOR 1 and BLIND SECTOR 2
Set area (up to 2) where no radar pulses will be transmitted, and the heading should be
adjusted before setting any sector. For example, set the area where an interfering object at
the rear of the scanner would produce a dead sector (area where no echoes appear) on the
display. To enter an area, enter start bearing relative the heading and dead sector angle. To
erase the area, enter 0 for both the START and ANGLE sections. The setting range of
START is 0 to 359° and ANGLE is 0 to 180°.
ANT REVOLUTION
Not used for FAR-2137S/2837S/2137S-BB.
ANT SW and ANT STOPPED
This is used for antenna maintenance by serviceman.
Note: Choose OFF at ANT SW to prevent the antenna rotation. As for ANT STOPPED,
choose STBY to prevent transmission while the antenna is stopped.
M SPEC and BB TYPE
Not used.
DUAL RADAR
See section 3.7.