Filter
Top Products
4-8
Positioning guide pins
The guide pins of the connector identify the mating receptacle. Position them as shown in the
table below.
Table 4-2 Guide pins and connector CN-E1
Connector
Guide Pin
CN-E1 Guide Pin Setting Tool
Guide Pin A (Large) 2
Type 10-910-0179-0
Guide Pin B (Small) 1
Clamping the cable
Cable clamp
Shield + armor
Anticorrosive sheath
Figure 4-11 Clamping the cable
Fabrication of cable 10S1259 (connected to terminal board TB-E1)
Armor
270
30 5
3.5sq
x 3
1.25sq
x 2
M4 (YEL) x 3
M4 (RED) x
2
Figure 4-12 Fabrication of cable 10S1259
Fabrication of cable DPYCY-3.5 (connected to terminal board
TB-E1)
M4 (YEL) x 2
Anticorrosive
sheath
Armor Vinyl
sheath
330
35
30
Conductor
S = 3.5 mm
ø = 2.4 mm
2
Vinyl
sheath
Armor
Cable DPYCY-3.5
Note: DPYCY-3.5 is Japan standard cable.
Use e
q
uivalent cable.
Figure 4-13 Fabrication of cable DPYCY-3.5