Filter
Top Products
9-3
Connectors for Monitor
There are two kinds of video signal ports: D-sub connector (default) and BNC connectors.
• D-sub: Use interconnection cable 3COX-2P-6C (5 m or 10 m) or equivalent commercially
available cable.
• BNC connector: Use five 75 Ω coaxial cables (shipyard supply). The coaxial cables are
preferred in case of longer than 10 m cable run between the processor unit and monitor.
The following modification is required to use the BNC connectors.
1. Dismount the RGB port panel at the rear of the processor unit.
2. Confirming the label attached to each BNC connector, connect each connector to its
corresponding port.
3. Mount the RGB port panel.
J3
J21
RGB port panel
Screw (4 pcs)
CONE board (10P6711)
R
G
B
H
V
Replace each
BCN connector
to the same
label port.
BNC connector
Processor unit (right side, cover removed)