Filter
Top Products
2-2
2.2 Antenna Unit
Antenna unit, front view
Fabricating signal cable RW-9600 and HV cable TYPCY-1.5
1. Use a ratchet or box wrench (diagonal 13 mm) to open port- and starboard-side covers on the
antenna unit.
2. Unfasten the gland nut for the signal cable and remove the gasket, flat washers (3 pcs.) and
gland cap. (The gland cap may be discarded.)
3. Fabricate the signal cable as follows:
a) Remove the vinyl sheath, armor and sheath by the amounts shown in the figure below.
b) Unravel the shield to expose cores.
c) Shorten cores (except coax) considering their locations on the terminal inside the antenna unit.
d) Shorten the shield, leaving 140 mm. Attach crimp-on-lug (FV5.5-4, yellow,
φ4) to shield.
e) Remove the sheath of cores by 6 mm.
f) Unravel armor.
g) Fix vinyl wire, coaxial cable and shield by taping the shield with vinyl tape at the location shown
below.
Fabricating signal cable RW-9600
Gland for signal cable (RW-9600)
Gland for power cable
(TPYCY-2.5)
Gland for HV cable (TYPCY-1.5)
Antenna safety switch
Ground terminal
Cover (right side)
20 mm
Shield
Armor
Vinyl
sheath
Sheath
350 mm
5 mm
Shield
Coaxial cable
Vinyl wire
330 mm
Shield
Fold back shield.
Core
6
14
59
Coaxial cable
Crimp-on lug
Taping
Unravel armor.