Filter
Top Products
1 - 3
O-ring
Radiator bracket
Waveguide
Antenna radiator
Hex bolt (M8X40), 8 pcs.
(XN20AF, XN24AF only)
Guide pin
(XN20AF,
XN24AF
only)
Hex bolt (M8X35), 8 pcs.
Flat washer
Spring washer
(XN12AF only)
Figure 1-3 Fastening the radiator to the radiator bracket
Fastening the scanner unit to the mounting platform
The scanner unit may be assembled before hoisting it to the mounting platform. However, do
not lift the scanner unit by the radiator. Always hold the unit by its housing. When using a crane
or hoist, lift the unit by the hoist rings which should be fastened to the bolt fixing covers of the
scanner housing.
CAUTION
CAUTION
DO NOT lift the antenna unit by the radiator;
lift it by the hoist rings. (Be sure to remove
rings after hoisting the antenna unit.)
Hoist
ring
NO!
1) Construct a suitable mounting platform referring to the outline drawing at the back of the
manual.
2) Drill four mounting holes of 15 mm diameter and one cable entry hole of about 50 mm
diameter in the mounting platform.
3) Lay the rubber mat (supplied) on the mounting platform.