Filter
Top Products
4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)
16
Installation of beacon receiver
Procedure
1. Disconnect 8P connector as shown in the figure below.
A
View
PH8P
J106
(P) MAIN
Panel assembly
Chassis assembly
Connector
A
Dismounting chassis assembly
2. Dismount chassis assembly from panel assembly by disconnecting connector shown in
the figure above.
3. Cut the cable ties as shown in the figure below.
Cut cable tie.
ANLG board
Cut cable tie.
J8
GN-8091
Cutting cable ties