Filter
Top Products
4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1850W)
17
Installation of beacon receiver
Procedure
1. Dismount chassis assembly from panel/chassis assembly by disconnecting the
connector and PH8P from J8 on MAIN Board shown in the figure below.
Chassis assembly
Connector
Panel assembly
PH8P
Remove two ties (CV-100).
Dismounting chassis assembly
2. Dismount heat sink from chassis assembly by unfastening three screws on the ANLG
board, loosening a screw at TR fixing plate and disconnecting the connector of the mini
pin coax cable.
ANLG board
Screws (3 X 8), 3pcs.
Mini pin coax cable
Heat sink
TR fixing plate
Chassis assembly