Filter
Top Products
44 GPSMAP 700 Series Owner’s Manual
Device Conguration
Device Conguration
Basic Device Conguration Questions
Question Answer
How do I adjust the amount of detail shown on the
map?
See “Changing the Map Zoom Detail” (page 8).
How do I change the time zone setting? See “Conguring the Time” (page 47).
How do I change the language setting? See “Setting the Language” (page 45).
How do I adjust the brightness of the backlight? See “Adjusting the Backlight” (page 2).
How do I show a compass tape at the top of the chart? See “Showing the Compass Tape on a Chart”
(page 49).
How do I change the color of the active track? See “Setting the Color of the Active Track” (page 31).
How do I delete the track log on the map? See “Clearing the Active Track” (page 31).
How do I transfer waypoints to a memory card? See “Chartplotter Data Management” (page 52).
How do I erase all waypoints, route, and tracks? See “Deleting All Saved Waypoints, Routes, and
Tracks” (page 32).
How do I check the software version and the map
version on the chartplotter?
See “Viewing System Information” (page 3).
Simulator Mode
WARNING
Do not try to navigate using simulator mode because the GPS receiver is turned off. Any satellite signal
strength bars shown are simulations and do not represent the strength of actual satellite signals.
Simulator mode turns the GPS receiver off for use indoors or for practice using the chartplotter. The
chartplotter does not track satellites in simulator mode.
Turning Simulator Mode On
From the Home screen, select > > > .
Conguring Simulator Mode
1. From the Home screen, select > > > .
2. Complete an action:
• Select , enter the speed of your boat in simulator mode, and select .
• Select. Select to allow the chartplotter to set the heading automatically, or
select to set the heading manually.
• Select , select the simulated position of your boat, and select .
• Select , enter the simulated time, and select .
• Select , enter the simulated date, select .
Turning the Chartplotter On Automatically
You can set the chartplotter to turn on when power is applied. Otherwise, the chartplotter must be turned on
using .
From the Home screen, select > > > .
: If Auto Power is and the chartplotter is turned off using , and power is removed and
reapplied within less than two minutes, you may have to press to restart the chartplotter.