Filter
Top Products
Av. Kit Install. Manual
190-00067-02 Rev. J
Page 20
4.2.8 CONFIGURATION
Select the Configuration Test Page. Change the selectable Strap and Fuel selections
to match that of the aircraft. The available options are:
Strap: Field Description
Lnav 1 Number 1 (Pilot) long range NAV
Lnav 2 Number 2 (Co-Pilot) long range NAV
common Common long range NAV
NOTE: The strap option affects the interpretation of RS-422 and ARINC 429
input data
For RS-422 input data the following applies:
Lnav 1 Only data marked for Lnav 1 is used
Lnav 2 Only data marked for Lnav 2 is used
common Data marked for either Lnav 1 or Lnav 2 is used
For ARINC 429 input data the following applies:
Lnav 1 Only data with SDI=0 or SDI=1 is used
Lnav 2 Only data with SDI=0 or SDI=2 is used
common Only data with SDI=0 is used
NOTE: SDI=0 is an all call.
Fuel: av gas Using Aviation gas (5.8 lbs/gal)
Jet A Using Jet A/Jet A-1 fuel (6.7 lbs/gal)
Jet B Using Jet B (JP-4) fuel (6.5 lbs/gal)
NOTE: The Fuel option is used to designate the type of fuel used so that the
correct fuel density will be used in calculations.
4.2.9 REMOTE BATTERY SETTINGS
Remote Battery: none
instld
NOTE: If instld is selected when a battery is not installed erroneous
voltages will be shown on the Power Test page and invalid battery messages
will be issued in normal operating modes.
Low Battery: selectable between 8.0 volts and 9.6 volts by 0.2 volt steps
NOTE: In normal operating modes, The Battery Low message will be
issued when the battery voltage is below the low battery value. The default
value is 9.0 volts.