Filter
Top Products
Page 8
SKU 92103/104/105 For technical questions, please call 1-800-444-3353
SYMBOLOGY
Table B
UNPACKING
When unpacking, check to make sure that all the parts are included. If any parts are miss-
ing or broken, please call Harbor Freight Tools at the number on the cover of this manual as
soon as possible.
INSTALLATION
WARNING: Electrical shock hazard. The wiring of the motor to the facility power circuit
must be done by a qualified electrician.
General
1. The ambient air temperature where the motor is to be installed cannot exceed 104° F.
If it does, cooling must be provided to ensure the temperature stays below the limit.
2. Do not block motor air vents.
3. This motor should be installed indoors in a clean, dry, and noncorrosive environment
where no flammable liquids or gases are present.
4. When mounting the motor for use, make sure all mounting hardware is securely
fastened. Make sure all hardware (not supplied) is securely fastened.
5. When mounting a pulley (not included) to the drive shaft, make sure it is properly
aligned or motor life will be significantly shortened.
6. Never operate motor without installing a safety guard (not supplied), with at least a two
inch clearance, around all pulleys and belts driven by this motor.