Filter
Top Products
4
signal from passing through.
Inside the hull installations require no holes to be drilled into the boat and
through experimentation, high-speed operation comparable to transom
mounting can be achieved. Two part, slow cure epoxy is required to glue the
transducer in place.
ALTERNATE TRANSDUCERS AND MOUNTING METHODS
The 425SX comes with everything necessary for installation and operation on
most boats. However, there are several situations which may require a different
type of transducer. Inboard boats, wood or metal hulls, and sail boats create
unique transducer mounting needs. Alternate transducers and mounting
methods are detailed below.
Portable Mounting
The standard transducer can be adapted for
portable installations using part number MHX-PT2.
This accessory adapts your transducer to a suction
cup mount for temporary installation on the boat
hull or other surface.
Trolling Motor Mounting
The standard transducer can also be adapted to
mount on most trolling motors using part number
AD-STM-7. This accessory includes a bracket and
hose clamp that allows mounting the transducer to
the body of most trolling motors.
TRANSDUCER EXCHANGE
Other transducers are available as replacements for the standard transducer.
You may exchange your new and unassembled transducer for another type by
returning it to the address listed in Customer Support. Some transducers may
have additional costs. Refer to the Accessory catalog or call Customer Support
for information.
INSTALLATION PREPARATION
ALTERNATE TRANSDUCERS AND MOUNTING METHODS