Filter
Top Products
TRANSDUCER PIVOT ASSEMBLY Assemble the pivot to the transducer main body using the
two 1/4x%" alien head screws, two %," tooth washers and two'/," square nuts. Make sure the
tooth washers are sandwiched between the transducer main body and the pivot. (See Figure 7).
The square nuts are trapped inside the pivot and will not rotate as the alien head screws an;
tightened. HOWEVER, DO NOT TIGHTEN AT THIS POINT (See Figure 7).
CAUTION: DO NOT APPLY LOCTITE® OR SIMILAR LOCKING COMPOUNDS BECAUSE
THEY WILL ATTACK THE PLASTIC.
Step 4
TRANSDUCER ASSEMBLY -Insert the transducer assembly into the metal bracket from the
bottom. Push up until the holes in the plastic pivot align with the uppermost holes in the bracket.
(See Figure 8). Slide the O-ring on to the headed pin and insert it through the two parts.
Assemble by screwing the '/,"x%" alien head screw into the head of the pin and tighten.
Step 5
ANGLE ALIGNMENT - Set the transducer angle so that it is parallel with the bottom of the boat
hull. (See figure 9). Once proper alignment is achieved, tighten the two alien head screws using
the %2" alien wrench provided. The screws are visible through the access holes on each side of
the metal bracket. Check to be sure the transducer main body is rigidly fastened to the pivot.
Step 6
CHECK POSITION OF TRANSDUCER At this point, check to see that the bottom of the
transducer is a minimum of %," below the bottom of the transom.
(However, as noted in STEP 2, the top of the transducer cannot fall below the bottom of the
transom). If it is not, remove the transducer assembly from the metal bracket by removing the pin
installed during STEP 3. (See Figure 8). Loosen the metal bracket mounting screws, reposition
the bracket utilizing it's slotted holes, tighten and reassemble. It may be necessary to replace the
silicone sealant after this adjustment is made.