Filter
Top Products
NOTE: It may be necessary to make several high speed runs to adjust transducer either
UP/DOWN or to readjust the angle to achieve optimum results.
Step 7 CABLE CLAMPS - Install cable clamps as necessary by drilling a %' dia. hole for the #8
screw supplied. Be sure to route the cable to the side of the bracket. The cable can be cut if it is
installed in the center of the bracket. (See Figure 10). FIGURE 10
3. INSIDE HULL MOUNTING PROCEDURE
Warning: In order to achieve proper results with this type installation, it is important that the
transducer be mounted by someone familiar with the use of two part epoxy adhesives. For this
reason, Techsonic Industries, Inc. will not be responsible for any damage due to the mounting of
your transducer in this manner.
IMPORTANT: Be sure to follow steps 3 through 6 to insure that a proper mounting location is
found. Do not epoxy the transducer until this is done. It may not be possible to find a good
mounting location on some boat hulls due to their construction.
1. Select as flat an area as possible near the aft end and center of boat where the hull is thin and
not double. If the bottom has a runner down the center of boat, select an area to one side of the
runner, but as close to the runner as possible.
2. Clean the inside of the boat with lacquer thinner in the area transducer is to be mounted.
Outside of boat in this area should also be cleaned. (Not with lacquer thinner.)