Filter
Top Products
CE: Conversion Instructions
Install new Hardware and IPL
yes
1
no
Model 825, 870, and 890 (with V5R2) Processor or Package Feature Conversion Instructions
Enter New System Password
WARNING: If The New System Password is
not entered, CUoD Screens will
not be accessible!
2
no
2
no
Enter code(s) on the server by using the
proper CUoD screen(s)
A) Print LPAR config
B) Power off any secondary partitions and
set to hold (don't IPL on system IPL)
C) Instruct customer to make "Available"
(LPAR state) all standby processors that
have been activated and assigned to partitions
D) Power off the system
For assistance with LPAR, see Information Center articles at:
http://publib.boulder.ibm.com/iseries/v5r2/ic2924/info/rzaj9/rzaj9iclpar.htm
Enter code(s) on the server by using the
proper CUoD screen(s)
IPL
(removes SRC4730)
no
yes
3
yes
A) Set Desired Power on status (hold/system)
and then power on any secondary partitions
B) Instruct the customer to use LPAR to assign
processors to target partitions
C) Return required upgrade hardware
yes
CE instructs the customer to use LPAR and
make available (LPAR state) the number of
processors identified in the attention message
Wait 5 Minutes for the server to register the new Activation and/or
Enablement Code(s) or the LPAR configuration change
Bypass Mode
A) Set Desired Power on status (hold/system)
and then power on any secondary partitions
B) Instruct the customer to use LPAR to assign
processors to target partitions
C) Return required upgrade hardware
A) Set Desired Power on status (hold/system)
and then power on any secondary partitions
B) Instruct the customer to use LPAR to assign
processors to target partitions
C) Return required upgrade hardware
2)
CE instructs the customer to check to see
if there are new Activation and/or
Enablement Codes to be applied. The
code(s) would be Included in the
shipment (paper) or posted at website:
www.ibm.com/servers/eserver/iseries/ondemand/cod
3) CE determines if the Op Panel
or PAL displays a 4730 SRC?
If this path is performed
within a powered on window
of 48 hours .. SRC 4730
will not be shown, and an IPL
will not be required to
eliminate the SRC and reestablish
the proper machine status
1)
CE determines if a message
(ATTENTION: CUOD CAPACITY CARD
ERROR, XX STANDBY PROCESSORS IN LPAR PARTITIONS)
is displayed on the
IPL or Install the System
screen and
SRC A6004716
is shown on the panel
27
12/15/2003