Filter
Top Products
8
3 BASIC OPERATION
New2001
■ Call channel programming
Call channel is used to select Channel 9 (default), however,
you can program the call channel with your most often-used
channels in each channel group for quick recall.
q Push both [Y] and [Z] on
the transceiver one or more
times to select the desired
channel group (U.S.A., In-
ternational or Canada) to be
programmed.
w Push [16•
9
] for 1 sec. to se-
lect the call channel of the
selected channel group.
•“CALL” and call channel num-
ber appear.
e Push [16•9
] again for 3 sec.
(until a long beep changes
to 2 short beeps) to enter
the call channel program-
ming condition.
• Channel number starts blink-
ing.
r Push [Y] or [Z] to select
the desired channel.
t Push [16•
9] to program the
displayed channel as the
call channel.
• Push [CH/WX•DUAL] to can-
cel.
• The channel number stops
blinking.
!IC-M422.qxd 05.2.23 2:20 PM Page 8 (1,1)