Filter
Top Products
8
SET MODE
30
Beep tone
Beep
Scan mode
Scan mode
Weather alert
WX alert
Scan resume timer
Scan timer
Attenuation level
Attenuation
level
Internal speaker
Internal
speaker
Scrambler code
Scrambler
code
Scrambler type
Scrambler
type
Dual/tri watch
DUAL/TRI
DSC watch
DSCwatch
LCD contrast
LCD
contrast
Push
916
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan mode (normal or priority), scan re-
sume timer, weather alert, dualwatch/tri-watch selection, DSC
watch, transceiver’s beep tone, internal speaker (transceiver
or HM-127), LCD contrast (transceiver or HM-127), RF atten-
uation level, scrambler code and scrambler type.
•Available functions may differ depending on dealer set-
ting.
•The optional HM-127 has it’s own settings for the beep
tone and LCD contrast.
q Turn power OFF.
w While pushing [16•9], turn power ON to enter set mode.
e After the display appears, release [16•9].
r Push [16•9] to select the desired item, if necessary.
t Rotate the channel selector to select the desired condition
of the item. Use [Y]/[Z] when using an optional HM-127.
y Turn power OFF, then ON again to exit set mode.
•SET MODE CONSTRUCTION