Filter
Top Products
47
11
COMMANDMIC
®
HM-127
New2001
■ Set mode programming
Set mode is used to change the condition of the transceiver’s
functions and the microphone’s own functions:
Transceiver’s functions—
scan mode (Normal or Priority,) scan resume timer, Weather
alert, Dualwatch/Tri-watch, DSC watch, transceiver’s beep
tone, LCD contrast (transceiver) and automatic acknowl-
edgement.
Microphone’s own functions—
beep tone function (microphone) and LCD contrast (micro-
phone.)
In this section, instructions are for the microphone’s own func-
tions only. Refer to pgs. 30 to 32 for the setting of the other
functions. (Some functions cannot be selected from the
HM-127.)
DD
Entering Set mode
q Turn power OFF.
w While pushing [16•
9], turn power ON.
• After a beep emission, a set mode item (in the channel comment
indicator and the condition in the channel number readout) is dis-
played.
e Push [16•9] to select the desired item, if necessary.
r Push [
YY
] or [
ZZ
] to select the desired condition of the item.
t Turn power OFF, then ON to exit Set mode.
• Beep tone “”
➥ Push [
YY
] to turn ON, [
ZZ
] to turn OFF the beep output.
• LCD contrast “”
➥ Push [
YY
]/[
ZZ
] to adjust to a suitable LCD contrast.
•
“” scrolls at the channel comment indicator.
Push
Scrolls
Scrolls
Push
11
!IC-M402A_SA.qxd 03.11.11 2:52 PM Page 47 (1,1)