Filter
Top Products
If you are using the 350TX in Simulator when no transducer is connected,
any selected options are lost when the unit is powered off. The 350TX will
return to Factory Settings, or options selected when last used with a
transducer, if no transducer is connected.
IMPORTANT: A transducer must be connected to the 350TX in
order to retain user settings selected when in simulator mode. If
no transducer is detected, the unit defaults to pre-selected
options when powered off.
What You See On-Screen
Your 350TX uses a 128 V x 64 H
matrix FSTN LCD display. This display
provides outstanding viewability in all
light conditions over a wide range of
temperatures.
At initial power-up, the 350TX uses
settings that were set at the factory.
After initial use, the 350TX will
remember the settings you enter.
There are several elements on-screen
that are common to all modes of
operation.
Temperature/Speed. The initial screen layout takes one of two basic
forms depending on whether the optional Temp/Speed accessory is
installed. Figure A shows the default view when the Temp/Speed accessory
is installed. Figure B shows the default view when the Temp/Speed
accessory is not installed.
Depth. The digital depth number shows the water depth directly beneath
the transducer location.
Depth Range. The depth range is shown to the right of the screen. The
upper number is 0 indicating the surface of the water. The lower number
is one of the nine depth ranges available that best match the depth of the
water. As the depth of the water changes, the range changes as necessary
in order to retain a bottom representation on-screen.
8
USING THE 350TX
WHAT YOU SEE ON-SCREEN
Figure A