Filter
Top Products
56
11
3
Press
[MENU]
to store the setting or any other key to
cancel.
4
Press any key other than
[MENU]
to exit Menu Mode.
The transceiver generates the following warning beeps
even if the Beep function is turned OFF.
• APO warning beeps {page 54}
• Weather Alert beep {page 36}
• Time-out Timer warning beep {page 62}
Note:
The beep output level is linked to the
VOL
control position.
BUSY CHANNEL LOCKOUT
This function is used to prevent transmitting on a
channel or frequency that somebody else is currently
using. When turned ON, an error beep sounds and
you cannot transmit even if you press Mic
[PTT]
while
another party is using the channel or frequency.
1
Press
[F]
,
[MENU]
and turn the
Tuning
control to
select Menu No. 22 (BCL).
2
Press
[MENU]
and turn the
Tuning
control to select
“ON” or “OFF” (default).
3
Press
[MENU]
to store the setting or any other key to
cancel.
4
Press any key other than
[MENU]
to exit Menu Mode.
FREQUENCY STEP SIZE
Choosing the correct frequency step size is essential in
selecting your exact receive frequency using the
Tuning
control or Mic
[UP]
/
[DWN]
. You can select your desired
frequency step size from:
2.5 kHz, 5 kHz, 6.25 kHz, 10 kHz, 12.5 kHz, 15 kHz,
20 kHz, 25 kHz, 30 kHz, 50 kHz, 100 kHz.
To change the frequency step size:
1
While in VFO Mode, press
[F]
,
[MENU]
and turn the
Tuning
control to select Menu No. 1 (STP).
2
Press
[MENU]
and turn the
Tuning
control to select
your desired frequency step size.
3
Press
[MENU]
to store the setting or any other key to
cancel.
4
Press any key other than
[MENU]
to exit Menu Mode.
Note:
If you change to a frequency step size that does not match the
current operating frequency, the transceiver automatically adjusts the
frequency to match the new frequency step size.