Filter
Top Products
50
communications and the operating system on
either end is compatible, check the Voice box.
(It is possible to enter the description using
double-byte characters. For the address, it is
also possible to enter the domain name,
provided that it can be resolved by DNS.)
Once you have finished, return to the setup
window, select the other computer in the To:
combo box, and check the box labeled Use
Network Command System. In the TX Control
frame, check DTS if the audio cable is
connected to the data terminal of the
transceiver; check PTT if it is connected to the mic and EXT-SP terminals. When you are finished,
click on OK.
The next step is to make the connection by clicking on CON, as you would with any other ARCP
software. If a normal connection is established, the green indicator lights on the CON button.
When you are connected using the KNS system, certain functions are not available. For details,
refer to ARCP/ARHP Help.
* In order to remotely control a transceiver via a
WAN, you must apply for permission. For
details, refer to the instruction manual and the
materials available on our website. Once you have obtained permission, you can use KNS for
remote control, but please make sure you follow correct operational procedure. The above applies
to remote control operations within Japan.
To use KNS via a WAN, you must obtain global IP addresses for the computers running
ARCP and ARHP to enable external access. Note that that when you open a broadband router
port you do so at your own risk.