Kenwood TS-570S Marine Radio User Manual


 
49
12 OPERATOR CONVENIENCES
Consult the following table to select a function.
Selecting OFF assigns no function to the button.
1 Press [MENU].
2 Press [A/B] to select Menu A or Menu B.
3 Turn the MULTI/CH control to select Menu No. 41,
42, 43, 44, or 45.
4 Press [UP], [DOWN], Mic [UP], or Mic [DWN] to
select a function number.
Consult the above table to select a function.
5 Press [MENU] to exit Menu mode.
The default values are as follows:
Front panel [PF]: Voice 1
Mic [PF1]: [A/B] • Mic [PF2]: [SPLIT]
Mic [PF3]: [M/V] • Mic [PF4]: Monitor
Note:
Full Reset returns the functions of the PF buttons to default
settings.
Function No. 84 accessible in step 4 is not currently available.
Pressing the PF button with Function No. 84 assigned will
simply cause the transceiver to display a string of error codes.
BEEP FUNCTION
The purpose of the Beep function is to provide an audible
signal that conveys information. There are three types of
signals:
•To confirm that a button has been pressed.
•To report an error condition; Morse codes are used for
some errors.
•To confirm that the selection was completed by
pressing [MIC], [PWR], [KEY], [DELAY], or [FILTER]
again.
When selecting an operating mode, a Morse code
abbreviation for that mode is heard.
You can change the volume of the beep output via Menu
No. 01.
DISPLAY DIMMER
The Display illumination can be switched between 5 levels
via Menu No. 00.
PROGRAM FUNCTION BUTTON
The transceiver allows you to customize the function of the
front panel [PF] button. When using the optional MC-47
microphone, you can also customize the functions of the
Mic [PF1], [PF2], [PF3], and [PF4] buttons. You can
assign the following types of functions to these buttons via
Menu No. 41 to 45:
Directly select Menu No. 00 to 40, 48 to 51. No need to
press [MENU] and turn the MULTI/CH control.
Activate a function that is supported by no other front
panel buttons.
Activate the same function as one of the front panel
buttons.
LSB
USB
CW
CW –R
FSK
FSK –R
AM
FM
· · · (L)
· · (U)
· · (C)
· · · · (CR)
· · (R)
· · · · (RR)
· (A)
· · · (F)
Morse Code Output
Mode
67
68
69
70
71
72
73
74
75
76
00 to 40
80 to 83
Function
Number
Function
Function
Number
Function
[SCAN]
[M>VFO]
[M.IN]
[CW TUNE]
[CH 1]
[CH 2]
[CH 3]
[FINE]
[F. LOCK]
[CLR]
Selects Menu
No. 00 to 40.
See “MENU
CONFIGURATION
.
50
51
52
53
60
61
62
63
64
Monitor
Voice 1
Voice 2
DSP Filter
Monitor
QUICK
MEMO [MR]
QUICK
MEMO [M.IN]
[SPLIT]
[TF-SET]
[A/B]
65 [M/V]
66 [A=B] OFF99
Selects
Menu No.
48 to 51.
Ex: 82
selects
Menu No.
50.