Filter
Top Products
8
Working with BLUETOOTH®
Leica DISTO™ A6 1.0.0 gb
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
RC
ROK
PL
H
RUS
CZ
Timer
Press and hold TIMER - key {A, 4} until desired time
delay has been reached (5 - 60 seconds).
Press DIST - key {A, 1}. Once the key is released the
remaining seconds until measurement are displayed.
The last 5 seconds are counted down with a beep.
After the last beep the measurement is taken.
Special function: Switch off of Beep
Pressing MENU - key {A, 10} and MINUS - key
{A, 13} together for 4 sec. switches the Beep off or
on.
Working with BLUETOOTH
®
Switching on BLUETOOTH® /
sending measurements
A quick press on the BLUETOOTH
®
- key {A, 14}
starts DISTO BLUETOOTH
®
. The data connection must
then be established out from Pocket PC / PC by the
application software. The BLUETOOTH
®
- icon in the
display {B, 14} will continue to blink until this has
been successfully completed. BLUETOOTH® automa-
tically switches off if the connection to the Pocket PC
/ PC is not established within 240 sec from when the
BLUETOOTH
®
was switched on.
Switching off BLUETOOTH
®
BLUETOOTH
®
switches off as soon as the DISTO™ is
switched off.
The direction keys
Eight direction keys (identified by a small arrow near
the key) on the operator's keypad are used to
manoeuvre the cursor. The direction keys become
active when you switch to the second level (by pres-
sing the 2nd key {A, 2}). The distance measuring key
is active in both levels. The functionality of the direc-
tion keys depends on the software used.
Transmitting the measurement
If your software supports the direction keys use them
to select the appropriate position for the cursor. To
transmit the measurement press the BLUETOOTH
®
-
key {A, 14}. The measurement is then transmitted to
your Pocket PC. For further details please consult
your manual for the software used.
During data transmission
If the data is not confirmed as being successfully
received by the Pocket PC / PC then no new measure-
ment can be processed. The Info code "240" appears
in the display if no data transmission has taken place
after 2 seconds. Press the CLEAR - key {A, 9} and
repeat the measurement and then transmit it.
Selecting particular values in the
display
By using the Min. / Max. function particular measure-
ments can be selected for transmission. The display
shows a number of measurements (min., max., last