Filter
Top Products
9
Appendix
Leica DISTO™ A6 1.0.0 gb
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
RC
ROK
PL
H
RUS
CZ
measurement taken). You can select a particular
measurement by using a longer press on the PLUS -
key {A, 3} or a longer press on the MINUS - key
{A, 13}. When selected the measurement blinks.
Once selected and blinking, the measurement can be
transmitted using the BLUETOOTH
®
- key {A, 14}.
The same selection process can be used for areas,
volumes, indirect measurements and room dimen-
sions.
Transmission of user-entered mea-
surements
A measurement on the display can be changed if you
wish. By pressing the EQUAL - key {A, 5} the value
blinks and can then be changed using the PLUS - key
{A, 3} and the MINUS - key {A, 13}. Pressing the keys
for longer increases the rate of change. Pressing the
EQUAL - key {A, 5} again confirms the change and
the value can be transmitted as normal.
)
NOTE
The free software supplied is designed to
provide the user with basic functionality. Leica
Geosystems provides no warranty for this free soft-
ware and offers no support for it. Leica Geosystems
accepts no liability whatsoever arising from the use
of the free software and is not obliged to provide
corrections nor to develop updates or upgrades.
You can find numerous commercial vendors of soft-
ware for a wide range of applications on our home-
page.
Appendix
Message Codes
All message codes will be displayed with either "InFo"
or "Error".
The following mistakes can be corrected:
InFo Cause Remedy
204
Calculation error Repeat procedure
206
No endpiece detec-
tion
Attach the endpiece
properly. If error still
occurs, replace the
endpiece.
240
Error in data trans-
mission
Repeat process
245
2nd key pressed
although no BLUE-
TOOTH
®
connection
exists.
Establish BLUE-
TOOTH
®
connection
252
Temperature too
high
Cool down instrument
253
Temperatur too low Warm up instrument
255
Receiver signal too
weak, measurement
time too long,
distance > 100 m
Use target plate
256
Received signal too
powerful
Use target plate
(grey side)
257
Wrong measure-
ment, ambient
brightness too high
Use target plate
(brown side)
260
Laser beam inter-
rupted
Repeat measurement