Filter
Top Products
2.3.1 Mounting bracket installation
1. Hold the supplied mounting bracket at the chosen location and use a soft pencil to
mark the 4 screw hole positions onto the mounting surface.
2. Drill the 4 screw holes where marked. Drill completely through the mounting
surface.
Note: If you are drilling into berglass, use a small drill bit to drill pilot holes before
drilling the screw holes.
3. Use the at screws, spring washers, plain washers, and nuts to attach the mounting
bracket to the location site OR, if you cannot reach behind the mounting surface to
attach the nuts, use the self-tapping screws instead of the at screws.
4. Slide the radio into the mounting bracket.
5. Insert the 2 mounting knobs through the holes and tighten them suciently to hold
the radio at your preferred viewing angle.
6. You can adjust the viewing angle at any time. The viewing angle has a 20º tilt range.
7. Now install the microphone wall hanger.
Lowrance - Link-8 Installation Instructions8