Filter
Top Products
2.3.2 Recessed installation
1. Tape the supplied mounting template to the chosen location. Ensure that the
template is smooth and taut.
2. Drill the 2 screw holes where marked. Drill completely through the mounting
surface.
Note: If you are drilling into berglass, use a small drill bit to drill pilot holes before
drilling the screw holes.
3. Drill through the corners of the hatched area where marked, then cut out the
hatched area to create a cavity in the mounting surface. (The dashed line shows the
total area that will be covered by the radio fascia after installation).
4. Remove the mounting template and slide the radio into the cavity.
5. Working from the rear of the bulkhead, screw the radio rmly to the mounting
surface using the 2 M5 x 32 screws with the plain washers and nuts.
(The screws should not be visible from the front of the radio).
6. Now install the microphone wall hanger.
Lowrance - Link-8 Installation Instructions 9