Filter
Top Products
8.3 TEMPERATURE DISPLAY FORMAT
(F/C DISPLAY) J5
Temperature may be displayed in Fahrenheit or Celsius
with this option.
8.4 SMART RECOVERY J6
Smart Recovery allows your HVAC system to attempt to
recover from a setback period and reach your desired
comfort temperature by the beginning of your
programmed comfort period. This jumper allows you to
choose whether to use Smart Recovery.
●
An initial Smart Recovery will start 1/2 hour before the
programmed comfort temperature.
●
Maximum Smart recovery time is one hour.
●
If enabled, Smart Recovery will initiate if:
●
Recovery is valid, from an evening setback to morning
comfort or day setback to evening comfort period
●
In Heat mode the set temperature of the comfort
period must be higher than the setback period
●
In Cool mode the set temperature of the comfort
period must be lower than the setback period
8.5 GAS/ELECTRIC MODE J7
This setting changes how the system’s blower fan (if
applicable) is controlled while in HEAT mode, and with
the Fan switch in the AUTO position. This setting does
not affect fan operation while in COOL mode. When set
to “Gas”, the fan is controlled solely by the heating
system itself. When set to “Electric”, the fan is controlled
directly by the thermostat. NOTE: If your blower fan does
not operate properly after installation, move the Gas /
Electric option to the “Electric” setting.
8.6 REPOSITIONING JUMPERS
Use the table on Page 12 to determine the jumper
position corresponding to the option you desire. The
table is also printed on the circuit board. If necessary
change the jumper position by pulling it straight off the
pins it covers. Replace the jumper over one pin for
OPEN, or both pins for CLOSED. When all changes have
been made, press the
Hardware Reset Button
. See
HARDWARE RESET.
These jumpers are located inside the thermostat on the
rear of its circuit board. To access them remove the unit
from the wall by pressing up on the thumb latch at the
bottom of thermostat, and swinging the body up and
away to separate them.
To change a setting, the jumper must be repositioned and
a Hardware reset must be performed. See HARDWARE
RESET.
9 BATTERIES/MAINTENANCE
Depending on your installation, your unit may require
batteries to control your HVAC system. Replace your
thermostats batteries at least once a year or when the
battery symbol appears in the display
9.1 BATTERY INSTALLATION
1. Remove fresh batteries from their carton.
2. Remove body of thermostat from the wall as described
in installation.
3. Remove the used batteries if present and replace them
within 90 seconds to avoid having to reset the day and
time.
4. Install two new "AA" size Energizer
®
or Duracell
®
alkaline batteries. Observe the polarity marking shown in
the battery compartment.
W A R N I N G:
Replace your thermostat’s batteries with new Energizer or
Duracell alkaline batteries at least once a year or when the
battery symbol appears in the display. Use of high quality
alkaline batteries is absolutely required for your thermostat
to operate properly.
5. Re-hang on it's base plate as described in installation.
10 TECHNICAL ASSISTANCE
If you have any problems installing or using this thermostat,
please carefully and thoroughly review the instruction
manual. If you require assistance, please contact our
Technical Assistance Department at 856-234-8803 during
regular business hours between 8:00AM and 4:30PM
Eastern Standard Time, Monday through Friday. You can
also receive technical assistance online anytime day or night
at http://www.luxproproducts.com. Our web site offers you
answers to the most common technical questions, and also
permits you to email your questions to our technical support
staff at your convenience.
11 WARRANTY
Limited Warranty: If this unit fails because of defects in
materials or workmanship within three years of the date of
original purchase, LUX will, at its option, repair or replace it.
This warranty does not cover damage by accident, misuse,
or failure to follow installation instructions. Implied
warranties are limited in duration to three years from the
date of original purchase. Some states do not allow
limitations on how long an implied warranty lasts, so the
above limitation may not apply to you. Please return
malfunctioning or defective units to the location from which
the purchase was made, along with proof of purchase.
Please refer to “TECHNICAL ASSISTANCE” before returning
thermostat. Purchaser assumes all risks and liability for
incidental and consequential damage resulting from
installation and use of this unit. Some states do not allow
the exclusion of incidental or consequential damages, so the
above exclusion may not apply to you. This warranty gives
you specific legal rights and you may also have other rights
which vary from state to state. Applicable in the U.S.A. and
Canada only.
9