Filter
Top Products
10
Step 1
Turn on the power to the receiver’s
housing.
Press and hold the button on the receiver until the LED turns
on solid.
Step 2
Solid LED
Learning an Additional Aquavibe Marine Remote Controller Code
Hold
While still pressing the button on the receiver, press and release the SRC button on the remote until the
LED on the receiver flashes 2 times, indicating the code is learned.
Flashes 2 Times
Keep Hold
Step 3
Release the receiver’s button and the LED will turn off.
Repeat Steps 2-4 to program additional remotes.
Note: Up to 4 remotes can be programmed.
Step 4
LED Off
Release Button
The Aquavibe Marine Remote Controller is already pre-programmed to the receiver. No programming is
necessary. If you want to program additional Aquavibe Marine Remote Controllers follow the instructions
below.
Note: This receiver will only retain the 4 Marine Remote Controller codes. If the receiver’s memory is
exceeded, the receiver will start deleting transmitters codes from memory in chronological order.