Filter
Top Products
8
Step 5
To exit programming push the switch on/off 5 times
or wait 15 seconds and the system will automatical-
ly exit the “Automatic Code Learning” mode.
or
Step 6
Try each button on the remote to make sure each
button has been learned properly. If the remote
does not function properly proceed to “Manual
Code Learning” section below.
Automatic Code Learning
(continued)
Manual Code Learning
Step 1
Turn on the power to the receiver’s
housing.
Press and hold the button on the receiver for 7 seconds. The LED
on the receiver will flash 3 times and then turn off. Release the
switch. You are now in “Manual Code Learning” mode
Step 2
Flashes 3 Times
7 Seconds
Within 15 seconds, aim the radio remote at the IR
input sensor and push the “VOLUME UP” button
on the radio remote.
Step 3
LED on Solid
Radio Remote
IR Input
Sensor
The LED will light up solid when the code has
been copied.
5 Times