Filter
Top Products
10. Ensure the bladder fabric is wrapped tightly around the CO
2
cylinder
and the hydrostatic inflator (Figures 14–16).
11. Remove the vacuum fitting from the oral inflation tube.
12. Detach the automatic/manual conversion cap (MA7219) from the
hydrostatic inflator. The pressure within the bladder should increase as
some gas enters through the water inlet valve. If the volume of gas
contained within the bladder does not noticeably increase, repeat steps 1-12.
13. On the oral inflator tube, turn the locking ring counterclockwise to
close the inflator valve and lock the mouthpiece in position.
Folding the Inflation Cell
1. Place the LP on a clean, flat surface with
the hydrostatic inflator face down, and
fold the inflation cell along each folding
line in sequence, numbers 1–11 (Figure 17).
2. Carefully but firmly wrap the outer casing
of the LP around the folded inflation cell,
secure with Velcro® tab and reset and close
the zippers.
Resetting and Closing the Zippers
NOTE: Mustang Survival uses advanced SecureZip™ 2-step zippers.
When performing this procedure, ensure the inflation cell does not get
caught in either zipper.
To reset and close the zippers:
1. Reset the zippers by pulling
each zipper pull back to the
Velcro® tab on the top of the
LP (Figure 18).
2. Close the zippers by pulling each
zipper pull to the zipper tape
ends at the top and bottom of
the LP (Figure 19), and fasten the
tab to keep the zippers closed.
3. Feed the zipper tape ends into
the small openings on the LP.
Figure 18
Figure 19
Figure 17
Figure 14 Figure 15 Figure 16
INFLATED DEFLATED VACUUMED
Tactical Inflatable Side Pouch LP Owners Manual
8