Filter
Top Products
Usage Below Freezing
When the temperature is below freezing, the Inflatable PFD should
be worn partially inflated because a fully discharged cylinder may not
quickly or adequately inflate your Inflatable PFD. Under these conditions
use the oral inflator to adequately top-up the PFD, after CO
2
inflation.
WARNING: CO
2
inflation could over-pressurize and damage your
Inflatable PFD if already fully inflated.
Re-arming Your PFD (MD3075)
NOTE: A re-arm kit (MA7203) is required for this procedure.
IMPORTANT: Follow instructions in the exact sequence below.
1) Open bottom cover flap so that manual inflator is exposed (Fig. 7).
2) Remove the cylinder/bayonet assembly by rotating counterclockwise
and then pull out. Discard the used cylinder/bayonet assembly.
3) Check the new cylinder/bayonet assembly to ensure the o-ring is in
place and the sensor ring is attached (Fig. 7). Ensure that the CO
2
cylinder has not been pierced (Fig. 7).
Inflatable PFD Owner’s Manual 6
Dust cap
position for
deation
Dust cap
in stowed
position
Oral Inator
FIGURE 6
Cap In
Deflate
Position
FIGURE 5