Filter
Top Products
7
2-2
Connecting the additional battery unit (
BUM100S/150S/300S
)
You can add only one additional battery unit.
2-2-1
BUM100S connection procedure / Connectable UPS: BU100SW/BU1002SW
(1) Remove the cover of the additional battery connector on the
back of the UPS.
Also remove the screws on the lower part of the signal card
expansion slot cover.
(2) Attach the clamps to the rear of the UPS and the BUM100S
using 2 screws each. For now, loosen the screw that fastens
the cable clamp and holds the cable.
● Use the screws removed in ➀ to attach the metal clamps.
(3) Connect the connection cable to the connectors on the backs
of the UPS and BUM100S.
(4) Insert the cable into the metal clamps attached in ➁, and then
tighten the screws (2 each).
When a 700W device is connected, the backup time is
30 minutes (initial battery value at an ambient
temperature of 20°C).
When the battery is completely discharged, it takes 24
hours to charge.
(5) Turn ON the overcurrent protection switch on the back of the
additional battery unit.
Loosen
Attach with 2 screws
Loosen
Attach with 2 screws
ø
Connect to
the connectors
ø
Tighten
Tighten
Overcurrent protection switch
➁
➀
➁
➀