Pelco Manual C935M (2/97) 5
Figure 1. Single-Monitor Installation
INPUT A OUTPUT A
INPUT A OUTPUT A
3.0 INSTALLATION
3.1 SURFACE MOUNT
The monitor has rubber feet and may be placed on any horizontal surface, such as
a desk or table.
3.2 CONNECTIONS
3.2.1 Single-Monitor Installation
Refer to Figure 1 and Table A for the following instructions.
1. Connect a 75-ohm video cable from the video source, such as a camera, to
the BNC connector labeled INPUT A on the back of the monitor.
2. Plug one end of the power cord into the back of the monitor and plug the other
end into a power outlet.