Filter
Top Products
Part 12
arrowed in same picture. Gently arrange the excessive length of this cable back
in the hole and screw-fit it back to the position originally occupied by the
cover. Please reserve the cover if there is chance to have the side mount kit
removed in the future.
DESKTOP MOUNTINGKS6115:258~355
Match the matching pegs on the back of the main unit against the
matching holes on the stand assembly. First aim the matching pegs toward the
upper round part of the hole and make sure that all pegs are inside the holes.
Then slide the main unit down to move the pegs into the lower slot part of the
holes till it clicks. Note that all the cables come out of the stand from the lower
edge and won’t get trapped by this mounting operation. If later on you want to
remove the main unit from the stand, you’ll have to press down the
lock/release button on back of the stand at the time lifting the main unit.
For desk top/counter application, the total dimension of slim base KS-
6215 occupies a space of 378 mm wide, 304 mm deep and 274 to 364 mm high
per main unit tilt angle. The universal base KS-6215 takes a space of 378 mm
wide, 304 mm deep and 304 to 394 mm high. The slim base KS-6217 is 410
mm wide, 342 to 304 mm deep and 290 to 400 mm high. The universal base
KS-6217 is 410 mm wide, 342 to 304 mm deep and 320 to 490 mm high. The
minimum height of above models shall be increased by about 4.5 mm if
InfraRed type touch panel is used.KS-6115U:294.5~391.5
WALL MOUNTING
The wall mount model is delivered without any base but with a wall
mount kit. Please follow the installation guide that comes with the wall mount
bracket to fix the wall mount bracket on wall and then hang the main unit with
the matching pegs into the matching holes on wall mount bracket.
Please note that since there is no base for the wall mount model there
can be no base installed device nor base mount kit. Consequently, the mass
storage device for KS-6215/KS-6217 series in wall mount application has to be
either the uDOC or the 2.5” HDD in main unit unless the type of wall mount
kit is checked and found to fit the usage.
Matching Holes
Matching Pegs
Round Part
Slot Part