Filter
Top Products
14
UNIDEN MHS050 Handheld VHF Marine Transceiver
Operation
Squelch
The squelch is used to eliminate any annoying background noise when
there are no signals present.
NOTE
Make sure to rst select a channel not in use before setting
the squelch in your MHS050 VHF Marine radio.
S1 - max sensitivity (min squelch)
S2 - med sensitivity (med squelch)
S3 - min sensitivity (max/tight squelch)
1. Press (sql) momentarily. S shows on the
display and the current squelch level will ash.
2. Press (sql) while the squelch level shows to
change the squelch level to the next step.
3. Press and hold (sql) to save and exit the
squelch setting.
10
SQUELCH
The squelch is used to eliminate any annoying background noise when there
are no signals present.
Think of squelch as a gate. Turn [SQ] fully
clockwise. This raises the "Squelch Gate" so high
that only the very strong signals can get through.
Turn [SQ]
fully counter clockwise until you hear a
hiss. This opens the "Squelch Gate" so that
everything gets through noise, weak signal, and
strong signals.
To set the "Squelch Gate" to the desired level, turn
[SQ] counter-clockwise until you hear noise. Then
turn the [SQ] clockwise just until the noise
stopped. Now only the desired signal can get
through.
If an incoming signal is very weak there is a
possibility that you will have a choppy or broken
reception, due to the sensitivity of the squelch.
In this case, simply rotate the [SQ] clockwise
until the weak signal is heard clearly.
Noise
Weak Signals
Medium Signals
Strong Signals
Make sure to first select a channel not in use before setting the
squelch in your UH076SX UHF-CB radio.
UH076SX
SCAN
TRI
TX
MEM US
LOCK
LOHI
INT
CAN
HI
HI
HI
LO
TX
LO
LO
LO
SCAN MEM
LO
TRILO
TRILO
FULL Power On/Off Volume
Squelch
To Transmit
and Receive - 1
To Transmit
and Receive - 2
One-touch Channel - 1 ScanningOne-touch Channel - 2
MEM
LO
LO
LOCK
LO
TRILO
Triple Watch - 1 Triple Watch - 2 Triple Watch - 3
Mem Monitor Lock