16
5. Tighten the nut on each DC terminal until it is snug. Do not
over-tighten.
6. Place the inverter’s lighter plug in the vehicle’s lighter socket or a
12 V outlet.
7. Turn on the unit by holding the switch located on top of the unit
until 888 is shown on the display.
The digital display will show the battery voltage, indicating that the
Digital Inverter is operating normally and AC power is available at
the outlet.
8. Plug in the AC product you want to operate.
When not in use always turn the inverter off by holding the switch until
the digital display turns off.
Connecting for Loads Over 150 W
You must connect the 400 W unit or 800 W unit directly to a 12 V
battery if you are going to operate loads greater than 150 W
continuously. When the inverter is connected this way, you can operate
loads of any size up to 320 W continuously with a 400 W unit and
640 W continuously with a 800 W unit.
XP_Digital_200-400-800.book Page 16 Wednesday, October 26, 2005 2:51 PM