8
1. Remove the electrical power from the
winch. (Switch Electric Winch Switch
to OFF)
2. Insert the handle so that it completely
engages with the driveshaft. The
handle can be cranked in either di-
rection with the clutch in the engaged
position.
3. Always remove the handle from the
winch after use.
ELECTRIC WINCH VERTICAL MAST OPERATION
VISUALLY INSPECT EQUIPMENT FOR
DAMAGE BEFORE OPERATING. ALLOW
ADEQUATE CLEARANCE AROUND TRAIL-
ER FOR TOWER AND INSURE THAT NO
PERSONS ARE STANDING IN UNDER THE
LIGHTS WHEN LOWERING.
TO LOWER TOWER AND LIGHTS
1. Turn off lights.
2. Operate the electric winch switch in
the down position to lower the lights
to the lowest vertical position.
3. Stop engine.
4. Rotate the light bar into the transport
park position (in line with trailer) and
engage the park pin by twisting on
the park pin ring until the plunger is
released and the pin engages the
hole in the light bar.
SAFETY WARNING!
6. Operate the electric winch switch to the
“up” position to raise tower to the de-
sired height.
7. If lights need to be adjusted for better
lighting of the work zone after raising the
tower, lower the tower using the “down”
switch position and make desired adjust-
ments to the light bar and light xtures.
Raise the tower into position. Repeat
this step if necessary.
NOTE: Ensure the detent pins are prop-
erly engaged in the outriggers before
towing.
AUXILIARY HANDLE
An emergency crank handle is provided
5. Reposition the lamp xtures for transport
by pulling them down into the lowest posi-
tion and face the
xtures toward the center of the trailer.
6. Remove ground rod from earth. Discon-
nect wire from ground lug and secure in
trailer
7. Raise jacks and rear stand, retract outrig-
gers and secure for towing
