480846-en-EU_V4.3 09/14
11
Data memory
The meter includes a non-volatile data memory that can store a maximum of 99 measured
values.
Storing individual measured values
MEM
The current memory location number appears in the lower right small display.
Once you press the MEM key, it will store a displayed value and increment the memory location
by one. Each flash of the “
” symbol display indicates one reading has been stored. When the
memory location number shows “99”, to indicate the manual data memory is full, the user must
clear the entire contents of the data memory before storing new values.
Reading individual measured values
Z
Y
X
Exit
Entry
Reading mode indicate
Reading memory location
X
Y
Z
1. Press READ key, the display shows “
”(reading mode).
2. Press ▼ or ▲ key to select the desired memory location.
3. Press the UNIT key to select the desired reading units.
4. Press the XYZ/CAL key to select the desired sensor axis reading.
5. Press the READ
► key to exit.
