1.6 Power Harness - DC Power Input
1) Connect the two (2) RED wires of the CP Power Harness to the “positive” of two (2) independent 12
VDC battery sources, (normally the PORT and STBD engine start batteries). At the point where the CP
Power Harness is connected to the positive power source, install a 10amp circuit breaker as close as
possible to the power source.
a. NOTE: ABYC standards require a circuit protection device
within 7” of the wire connection to the power source.
2) Connect the YELLOW wire of the Power Harness to the “negative”
connection of either battery source.
a. Verify that the negatives of the inde-
pendent battery sources are connected else-
where on the boat.
1.7 Bonding Wire
Run a bonding wire (#12 AWG, green jacket)
from the bonding stud (1/4”) located top right on
the connector side of the Control Processor to the
bonding strip provided by the boat manufacturer
EEC4 Installation Manual
10
bonding
stud
Connect control system
enable harness where
jumper was removed
Connect jumper to “piggy-back”
connector on control system
enable harness
4
5
piggy-back
connector
to vessel
adapter harness
to vessel
adapter harness
keyswitch jumper
that was removed in
step #3
piggy-back
connector
control system enable plug
insert 4-pin control system plug